Band-it Ball-Lok Installation User Manual download pdf

BAND-IT-IDEX, Inc.

A Unit of IDEX Corporation

4799 Dahlia Street

Denver, CO 80216-3070 USA

P: 1-800-525-0758

F: 1-800-624-3925

Document # P98187 rev. B

BAND-IT-IDEX, Inc. 2006

www.BAND-IT-IDEX.com

Page 1 of 1

BAND-LOK Ties

Installation

Instructions

Warning:

Always wear safety glasses when assembling and tensioning ties.

2. Wrap tie around object. Insert

tail end of tie through slot at

opposite end.

3. With needle nose pliers

pull tie to desired tension.

1. Bend tail back over the hood.

4. Using tin snips cut tail end

so that approximately 1/4”

extends out from the hood.

6. Tap the tail and hood down

lightly for a lower profile.

For consistent automatic tensioning of multiple ties, use the A95079 hand tool. This

tool will insure consistency by automatically cutting off after a desired tension in

reached.

Refer to website for warranty information:

http://www.band-it-idex.com/warranty.html

5. With needle nose pliers tuck tail end

under the hood (bend hood up slightly

if necessary).

BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925 Document # P98187 r

No comments

Band-it Ball-Lok Installation User Manual